Abstract

One of the characteristic features of high loaded low-pressure turbine (LPT) with a low flow coefficient is the high-level flow deflection in the blade rows, which have sufficiently thin and strongly curved cross-section profiles. Such profiles are very sensitive to off-design flow angles, especially to positive incidence. Therefore, the effectiveness of a high loaded LPT strongly depends on the working conditions. At the same time, for various reasons, in the process of research tests or operating the engine, the operating conditions may differ greatly from the design ones. Therefore, the creation of a robust LPT design is an actual task. The article considers the computational approbation of the method of increasing the resistance to large off-design angles of attack of vane and blade rows of the intermediate stage of a high loaded LPT of an experimental engine by changing the shape of the leading edges. The turbine was previously tested as part of a full-scale engine, where it was determined that the operating conditions of the LPT and its efficiency are significantly different from the calculated ones. Numerical (CFD) analysis of the flow showed that one of the reasons for the low efficiency is the large angles of attack on the vane and blade rows of the second stage, which lead to the flow separation and an increase of the energy losses coefficients at final. The modernization of the profiles was carried out by reducing the radius and a local increase of the leading edges wedge angle without changing the basic profiles. According to the calculation results, it was allowed to significantly improve the stream. The intensity of the flow deceleration behind the shock wave at the point of transition from the circumference of the edge to the suction surface was reduced, this made it possible to eliminate or reduce the intensity of the flow separation in the vane row and significantly reduce the energy losses coefficient. A more favorable flow was also achieved in the blade row, where a slight decrease in the losses coefficient was also obtained. As a result, the efficiency of the stage and the whole LPT was increased at the off-design operating conditions. This approach can be recommended both to increase the efficiency of the turbine at the experimental development, and when designing new turbines to increase their robustness.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call