경남 통영 해수양식진주의 광택에 대한 광물학적 연구

Abstract

A mineralogical analysis on the factors affecting the luster of pearls was carried out using gravity measurement, optical microscope observation, X-ray diffraction analysis, and scanning electron microscopy. We divided the seawater cultured pearls from Tongyeong into the following four types based on luster and shape; good luster and round (LR), lackluster and round (LLR), lackluster and baroque (LLB), and lackluster and two nucleus (LTN) pearls. Pearls with high-quality luster had slightly lower specific gravity as compared to pearls with low-quality luster, but both these types of pearls are within the specific gravity range of commercial pearls. Regarding the cross-sectional thickness of the mother-of-pearl layer, LR pearls showed a uniform thickness of about 0.3 mm in average. On the other hand, LLR pearls were characterized by relatively thinner, but uniform thickness. LTN and LLB pearls showed a tendency of significantly large variation in thickness even within a single pearl. For the surface of pearls, pearls with high-quality luster showed narrower and clearer growth lines of aragonite crystals as compared to pearls with low-quality luster. Pearls with high-quality luster were characterized by fewer aragonite crystal lattice defects as compared to pearls with low-quality luster, and the former showed parallel arrangement, thinner thickness, and less difference in thickness on the surface and inside. If a pearl has a prismatic layer, it is composed of aragonite with calcite in the prismatic and nacreous layer, and calcite content is very high in the lackluster pearl. Pearls without a prismatic layer were devoid of calcite irrespective of their quality of luster, and were composed of aragonite.