브래지어 컵 사이즈를 반영한 바디스 원형 개발

Abstract

The purpose of this study was to compare fitting of the upper garment by brassiere cup size and types of bodice block. This study conducted a 3D virtual garment system by applying three types of bodice block (I, II, III) and experimental pattern of the bodice block to 3D avatars of four individuals with the following measurements: under bust circumference of 73.5 cm and bust circumferences of 83.5 cm, 86.0 cm, 88.5 cm, and 91.0cm. The results of the study were as follows. First, for 83.5 cm bust circumference (A Cup), appearance of the three types of bodice block (I, II, III) was appropriate. However, as bust circumference increased in size, shape became inappropriate. The depth and width of the armhole, within 15 cm and 11 cm, respectively, were found to be appropriate. In case of 91.0 cm bust circumference (D Cup), all three bodices (I, II, III) were inappropriate. Second, the results of the draft of the experimental patterns of the bodice block of bust circumference measuring 83.5 cm, 86.0 cm, 88.5 cm, and 91.0 cm in the 3D avatars of the four individuals revealed similarities in the frontal view of the silhouette in the four avatars; in the case of the lateral view of the silhouette, lateral width grew wider as bust circumference of the silhouette became larger, but the shape of armhole showed no changes. The depth of the armhole showed little changes from 15.1 cm to 15.22 cm, and the height of sleeve (armscye depth 13.6 cm within +2 cm) remained similar. The difference in width of the armhole from 11.26 cm to 11.37 cm was rather small. The width of the upper sleeve (8.97 cm) seemed to be appropriate as it remained within the 2-3 cm boundary.