Abstract

Рассмотрены аналитические модели превращения аустенита в стали, учитывающие влияние напряженного состояния на скорость превращения при термообработке сталей. Предложены простые аналитические выражения для расчета скорости и количества образующегося мартенсита в зависимости от величины напряжения в γ-фазе.

Highlights

  • Christian J.W. The Theory of Transformations in Metals and Alloys, 1st Edition, Pergamon Press, Oxford, UK, 2002

  • The analysis of the presented works shows that mathematical modeling of austenite decomposition during heat treatment is possible using both ТТТ and ССT diagrams

  • Тhe effect of the stress-strain state arising in the process of heat treatment of parts on the kinetics of structural transformations is usually not taken into account

Read more

Summary

Introduction

Christian J.W. The Theory of Transformations in Metals and Alloys, 1st Edition, Pergamon Press, Oxford, UK, 2002. Krot P.V., Bobyr S.V., Dedik M.O. Simulation of backup rolls quenching with experimental study of deep cryogenic treatment / Int. J. of Microstructure and Materials Properties, 2017, Vol.12, No.3/4.

Results
Conclusion

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.