Эффективность абляции металлов сканирующим пучком импульсного излучения волоконного Yb:YAG лазера наносекундного диапазона длительности

Abstract

The results of experiments on ablation of targets made of stainless steel and aluminum by a scanning beam of nanosecond pulses at intensity up to 109 W/cm2 are presented. It was found that the overlap of the impact zones during irradiating leads to an increase in the ablation depth in proportion to the area of overlap of the irradiation spots. This is due to increase in overlap irradiation spots degree, zones with a large number of pulse effects are formed on surface, which increases the depth of the melt bath and leads to the ejection of larger particles. An increase in ablation depth of aluminum increase with increase of the interval between pulses up to 10 ms and overlapping of the irradiation spots. The shape of the ejected particles changes from spherical, when formed from a melt, to an irregular shape, when the target is mechanically destroyed by an internal shock wave. The size and velocity distribution of the ejected particles was determined, and on the basis of these data, the laser radiation shielding coefficients were calculated depending on the degree of overlapping of the irradiation spots. It was found that the main mechanism for the decrease in the efficiency of ablation by a scanning beam of radiation is the backflow of microparticles deposited on the target surface. The analysis of the energy balance of the aluminum ablation process is carried out.