Abstract
In the paper there is considered a problem of properties heterogeneity in a terminal pair under conditions of computer-aided manufacturing. It is emphasized that this circumstance results in decrease of stability and quality of machining on the whole. The existence of tolerances for the content of chemical elements in steel is caused by a complexity in control of metallurgical processes. 
 It is offered to use a parameter of thermo-electromotive force of a terminal pair “tool-blank” obtained in strictly definite modes of a calibrating cut for the further definition and optimization of cutting modes for machining. Drawbacks and possible variants for their solution at the realization of a method to measure cutting-electromotive force under production conditions are emphasized. A complex approach to the assessment of the influence of cutter geometrical parameters and technological factors of production upon the value of a thermo-electromotive force signal of a natural thermocouple “tool-part” is presented. It is established experimentally the influence of the antiwear coating state upon a thermo-electromotive force signal.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Science intensive technologies in mechanical engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
