Abstract
A deburring system using the joint of revolute robot manipulator with a tool holder was developed for deburring automation. The tool holder composed of the plunger with spring was developed for freedom of three degree operation. The tool holder was applied for compensation of position errors during trajectory tracing or deburring the workpiece of ununiform. To reduce interacting forces between the high stiffness tool at the end effecter and the workpiece during deburring operation, it was developed to operate flexibly to the direction of tangent line on the revolute axis and to the direction of axis. In this paper, using the deburring system attached at the revolute robot manipulator, deburring experiments were performed. According to the experimental results, the good performance of the proposed deburring system using the revolute robot manipulator was shown.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of the Korean Society of Mechanical Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
