Abstract
The article analyzes the most successful results of riveting and Assembly work, the use of anti-friction coating on the beds of the Assembly device, and reflects the advantages and technical capabilities of production at the current stage of development. The problem statement is formulated as follows: it is necessary to find the optimal parameters of the technological process in the production of aircraft components used in the design of short-and medium-haul aircraft. The optimal technological process in terms of time resources, material costs, and design weight at different levels of serial production were considered as optimization criteria in this study. Numerical modeling and optimization of workflow parameters were performed in the NASTRAN СAE system (NX). For each of the combinations of optimized process variables, parameters were determined based on numerical modeling. Analysis of the optimization results showed that the growth of parameters of the working process leads to an expansion of the area of locally optimal parameters. With optimal parameters of the working process, you can expect to optimize the cost of work up to 30 percent.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Izvestiya of Samara Scientific Center of the Russian Academy of Sciences
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
