Abstract
Calculations of stress-strain state of pipelines are performed in accordance with the unified regulatory requirements, which do not take into account facilities operation. Thus, the limitation of minimal allowable bend radius with the value of 1000 pipe diameters (1000D) can be considered justified in relation to a new construction project, but the problem is that it is applied to all pipelines independently of its service life. At the same time the modern smart pigging technologies allow for obtaining precise data on bend radius of operated pipelines, and the diagnostics results indicate, that mandatory requirement for minimal value of 1000D frequently contradicts the actual technical condition of researched objects. The authors performed the analysis of standard formula for calculation of longitudinal stresses, considered the impact on the calculated value of its separate constituents: values of pressure, temperature difference and bend radius. The conclusion is made about the necessity for reassessment of the current regulations for scientific justification of acceptable values of pipeline longitudinal stresses. It is established, that the primary factor, which is responsible for forming the value of longitudinal stresses of the pipelines during long-term operation is the bend radius.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: SCIENCE & TECHNOLOGIES OIL AND OIL PRODUCTS PIPELINE TRANSPORTATION
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.