Структурно-морфологические свойства вторичного волокна из влагопрочного сырья при мягком размоле. Часть 2. Характеристика волокнистой мелочи

Abstract

The process of recycled pulp refining is usually associated with a significant change in the morphological characteristics of the secondary fiber and the formation of additional amounts of fines. It is well known that fines have a great impact on the pulp properties, the papermaking process and the quality of the resulting paper. At the same time, the effect of fines both on the paper properties and on the papermaking process depends on the morphological characteristics of the fines. The aim of the study was to evaluate the changes in the morphological characteristics of the fines during gentle low-consistency refining of the recycled pulp. The recycled pulp was obtained from commercial wet-strength tissue paper, consisting of 100 % bleached softwood kraft pulp (BSKP) made from pine (Pinus sylvestris L.). The repulping of wet-strength paper was performed at 60 °C in three ways, namely, repulping with sodium hydroxide (indicated as RP (NaOH)), repulping with sodium hydroxide and sodium persulfate (RP (NaOH + Na2S2O8)), and finally repulping with sodium hydroxide and potassium monopersulfate (RP (NaOH + KHSO5)). Using an optical fiber analyzer, L&W Fiber Tester, it was found that accelerated persulfate and monopersulfate repulping of the wet-strength paper led to an increase in fines content after pulp refining by 0.20…0.28 % on length and by 0.9…1.5 % on number of particles. In addition, some fines were not detected due to the limited resolution of the measuring device. The morphological characteristics of the recycled pulps showed that the studied fines were relatively straight particles (Sl = 93.5...94.0 %) with low length polydispersity ((Ll/Ln) = 1.08...1.09). Fines had a mean slenderness ratio (L/W)l and (L/W)w of about 7, which in some length classes reached 8...9. Taking into account the experimental data on fines length (Ll = 132…134 µm) and fiber width (Wl = 29.7…30.0 µm), as well as SEM images of recycled paper, we can conclude that these particles can form fines-assisted bridges between several close deposited fibers in the fiber network, thus strengthening the paper web. For citation: Penkin A.A., Kazakov Y.V. Changes in the Morphological Characteristics of Secondary Fiber Obtained from Wet-Strength Paper During Gentle Refining of the Recycled Pulp. Part 2. Fines Characteristics. Lesnoy Zhurnal = Russian Forestry Journal, 2023, no. 4, pp. 169–179. (In Russ.). https://doi.org/10.37482/0536-1036-2023-4-169-179