Abstract
The effect of negative temperatures on strength characteristics of plastic component joints (hot gas welding, gluing, 3D-welding) made with the use of additive technologies has been examined. It has been found out that 3D-wlding allows one to produce joints with the highest strength properties. It was shown that low temperature values (–30 °С) did not have the negative influence on strength properties of ABS-plastic joints but even increased them as compared with analogues samples tested at the room temperature.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
