Abstract

The deformation process of powder materials thin-walled bushings manufacture was investigated by computer modeling. Two shape formation bushings schemeswere considered (direct extrusion and radial compaction).A continuum approach was used to create a modeling method. The method is based on rheological models of porous body plastic deformation and the finite element method. The accepted material rheological model allows describing the deformation of both powder and porous blanks. It takes into account the different resistance of these materials in tension and compression. Modeling of the deformation process was carried out in stages, using the method of successive loads. The elastic stresses were determined, the plastic potential was calculated and, if it was necessary, the stresses and material parameters of the model were corrected at each load step. The porosity value is reach maximum in blank and area, that is free from the loads, and the accumulated deformation is reachminimum in direct extrusion. The effect of back pressure leads to a more uniform distribution of these parameters, a decrease in porosity and an increase in the accumulated deformation of the solid phase. During radial compaction of thin-walled bushings, deformation of the material occurs locally. Porosity in the product section increases with increasing radius. Increasing the number of technological transitions with a gradual increase in the forming tool diameter reduces the uneven distribution of residual porosity and its value. However, the unevenness of the porosity distribution over the radius remains. In the process of radial compaction, a burr is formed on the ends of the product. The burr can be reduced by changing the initial shape of the blank. The process of direct extrusion allows obtaining more uniform distribution of residual porosity and accumulated plastic deformation of product material. However, this technological process requires the higher loads application, which leads to less stability of the tool. The radial compaction method (which characterized by local deformation) requires not high loads and allows not powerful equipment using. However, the distribution of residual porosity over the radius of the bushing is uneven. Keywords: plasticity theory, powder materials, computer modeling, finite element method, stress-strain state, porosity distribution.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call