Abstract
The results of the analysis of calibration mixtures of formaldehyde and methanol in nitrogen with a device for vapour-phase analysis with dosing loops of 5-20 cm 3 in volume and conditions of the analysis providing compact sample injection from loop to the analytical column are presented. The analysis data of low molecular organic compounds by means of the device for vapour-phase analysis with a dosing loop of 15 cm 3 on the analytical column with polyphenylchinoxaline are given. It is shown that the plywood contains methanol in 7-8 times more in comparison with formaldehyde and methylal was not detected, indicating on its decomposed in pressing plywood. The urea-formaldehyde resin contains methanol in 2.4 times and methylal - in 3.6 times more as compared with formaldehyde content. In simulated conditions at saturation 0.4 and 1.0 m2/m3 the plywood liberates formaldehyde above the permissible level to 2.2-8.0 times . Key words: gas chromatography, device for vapour-phase analysis, plywood, veneer, urea-formaldehyde resin, formaldehyde, methanol, methylal (Russian) DOI: http://dx.doi.org/10.15826/analitika.2013.17.2.010 V.B. Khabarov Federal State Budgetary Foundation of Science A.N. Frumkin Institute of Physical Chemistry and Electrochemistry of the Russian Academy of Sciences, Moscow, Russian Federation
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.