AbstractSCMs with a large specific surface area, such as calcined clays or fine limestone powder, can significantly accelerate the occurrence of the aluminate heat flow peak during the early hydration of blended cements. These systems therefore require a higher amount of sulfate. While this effect has been drawn back to the sulfate incorporation into C‐S‐H, which is formed more rapidly due to the filler effect, it has been recently shown that in systems with high amounts of metakaolin, the sulfate balance is influenced by further mechanisms. This study provides new results on the influence of aluminum‐rich and aluminum‐free SCMs on the early hydration of alite in presence of calcium sulfate. A synthesized alite was blended with 5 wt% of anhydrite and its hydration was investigated by isothermal calorimetry and in‐situ XRD at a w/b ratio of 0.5. It was shown that the formed C‐S‐H is able to take up the calcium and sulfate ions, indicated by a depletion of the solid anhydrite after approximately 20 hours. This process is significantly accelerated by incorporating 30 wt% of a fine limestone filler. The addition of metakaolin leads to an acceleration of the alite hydration compared to the reference as well, but to a significantly lower extend compared to the limestone. However, this system requires a lower degree of alite reaction to reach sulfate depletion. This indicates that in metakaolin‐rich systems, the sulfate demand is influenced by further effects. The results from in‐situ‐XRD reveal that significant ettringite formation is taking place in the metakaolin‐blended system already during the first hours of hydration. Correlations between the degree of alite hydration and the rate of sulfate depletion provide new insights into the mechanisms affecting the sulfate balance and early hydration of blended cements.
Read full abstract7-days of FREE Audio papers, translation & more with Prime
7-days of FREE Prime access