Background: The color stability of dental restorative materials is important for long-term clinical success. Objectives: The objective of this study was to examine the effect of thermocycling on the color and translucency stability of monolithic zirconia. Materials and methods: A total of 80 disc-shaped specimens (1 cm diameter) were produced from monolithic zirconia material, Katana High Translucent (Kuraray Noritake Dental, Kurashiki, Japan). The specimens were prepared in four different thicknesses: 0.5 mm, 1 mm, 1.5 mm and 2 mm. Before thermocycling, color measurements of the specimens were made by a spectrophotometer (Spectro Shade TM MICRO; MHT Optic Research AG, Milan, Italy). After the thermal aging procedure, the color measurement was repeated. Data obtained from the study were analyzed with descriptive statistics, correlation analysis, one-way ANOVA and Tukey’s tests. Results: After thermocycling, the L*, a*, b* values decreased at all thicknesses. The maximum change in the L*, a* and b* values was observed in 0.5-mm-thick specimens, while the least change was observed in 2-mm-thick specimens. The amount of color change in the specimens after thermocycling was found to be the highest in 0.5-mm-thick specimens (ΔE = 0.91 ± 0.02), and the lowest in 2-mm-thick specimens (ΔE = 0.85 ± 0.01). While a statistically significant color change (ΔE) was observed in 0.5-mm-thick specimens (p E) was observed (p > 0.05) in 1-mm, 1.5-mm, and 2-mm-thick specimens. After thermocycling, the translucency parameter (TP) values decreased at all thicknesses. The highest change in the TP values was observed in 0.5-mm-thickspecimens (1.09 ± 0.03), while the lowest change was observed in 2-mm-thickspecimens (0.40 ± 0.04). While a statistically significant change in the TP values was observed in 0.5-mm-thick specimens (p 0.05). Conclusion: Although the color and translucency values after thermocycling exhibited statistically significant changes in the 0.5 mm thickness group, a statistically significant difference was not observed in the other thickness groups.
Read full abstract