Supercritical Power Unit Research Articles

Life cycle assessment analysis of supercritical coal power units

Life cycle assessment analysis of supercritical coal power unitsThis paper presents the Life Cycle Assessment (LCA) analysis concerning the selected options of supercritical coal power units. The investigation covers a pulverized power unit without a CCS (Carbon Capture and Storage) installation, a pulverized unit with a "post-combustion" installation (MEA type) and a pulverized power unit working in the "oxy-combustion" mode. For each variant the net electric power amounts to 600 MW. The energy component of the LCA analysis has been determined. It describes the depletion of non-renewable natural resources. The energy component is determined by the coefficient of cumulative energy consumption in the life cycle. For the calculation of the ecological component of the LCA analysis the cumulative CO2emission has been applied. At present it is the basic emission factor for the LCA analysis of power plants. The work also presents the sensitivity analysis of calculated energy and ecological factors.

Life Prediction of High Temperature Welded Component by Skeletal Point Rupture Stress

At the present time, as the steam conditions and capability of the supercritical power unit increasing, the unit reliability is an important factor for the unit efficiency. High temperature, thick walled pipes are widely used in power plants and chemical plants. In this paper, life of the welded joint was predicted by the methods of skeletal point (SP) rupture stress rupture stress, which was calculated by finite element method (FEM). For the life prediction of welded component, the continuum damage mechanics was employed too. The life prediction of the welded joint by SP rupture stress was compared with the life prediction by the method of continuum damage mechanics (CDM). The research results showed that the two predicted methods were consistent. So, it can be concluded that the SP rupture stress can be used for predicting life of the high temperature welded component. The SP rupture stress method was used conveniently for the structure of power plant or other high temperature components.