The EUREF Permanent Network (EPN) currently consists of more than 300 evenly distributed continuously operating Global Navigation Satellite System (GNSS) reference stations. As a result of the continuous modernization of GNSS systems, the equipment of reference stations is subject to changes and upgrades. Changes relating to GNSS receiver antenna replacement are considered the main reason for discontinuities noticed in station position time series. It is assumed that resulting offsets are primarily caused by changes in carrier phase multipath effects after antenna replacement. However, the observed position shifts may also indicate the deficiency in the antenna phase center corrections (PCC) models. In this paper, we identified and interpreted the coordinate shifts caused by antenna/radome changes at selected EPN stations. The main objective was to investigate the correlation between the offset occurrence and PCC model type (type mean, individual robot-derived, individual chamber-derived) as well as multipath changes after antenna replacement. For the study, GNSS data from 12 EPN stations covering the years 2017–2019 were analyzed. The results proved that the antenna replacement is critical in the context of station coordinates stability and, in most cases, results in visible shifts in the position component time series. For GPS-only solutions, the most stable results were achieved using robot-derived individual PCC models. On the other hand, in the case of GPS + Galileo processing, the most stable results were obtained using chamber-derived individual PCC models. Furthermore, discontinuities due to the antenna change were noticed in the position time series in 75% of GPS + Galileo solutions. On the other hand, multipath changes arising as the result of antenna replacement were responsible, depending on solution type, for 21–42% of variations in the coordinates.
Read full abstract7-days of FREE Audio papers, translation & more with Prime
7-days of FREE Prime access