Properties Of Track Membranes Research Articles

Effect of a Deposited Silver Film on the Deformation Strength Properties of Track Membranes

Effect of a Deposited Silver Film on the Deformation Strength Properties of Track Membranes

Исследование влияния низкотемпературной плазмы и паровой стерилизации на свойства трековых мембран из полиэтилентерефталата

Исследование влияния низкотемпературной плазмы и паровой стерилизации на свойства трековых мембран из полиэтилентерефталата

Track membrane with immobilized colloid silver particles

A method for modification of track membranes by immobilization of polymer complexes of colloid silver nanoparticles on the surface of microfiltration membranes was developed. The antimicrobial properties of track membranes modified with silver nanoparticles were tested on E. coli, Ps. aeruginosa, St. aureus, and B. cereus.

Properties of polymer track membranes modified by grafting with poly(2-methyl-5-vinylpyridine) and poly(N-isopropylacrylamide)

The properties of track membranes (TM) based on poly(ethylene terephthalate) (PETP) and polypropylene (PP) and modified by radiation-induced graft polymerization of 2-methyl-5-vinylpyridine (MVP) andN-isopropylacrylamide (NIPAA) were studied. The rate of grafting and the limiting degree of grafting increase linearly as the pore diameter of TM increases. The gasdynamic and hydrodynamic pore diameters of modified TM were determined. The dependence of water permeability of TM modified by grafting with poly(2-methyl-5-vinylpyridine) (PMVP) on the degree of grafting passes through a maximum, which, according to the data of wetting angle measurements, corresponds to the maximum hydrophilicity. The negative χ-potential of TM changes sign after modification by grafting with PMVP. Thermosensitive TM based on PETP and PP were prepared by radiation-induced graft polymerization of NIPAA. The structure of modified TM was studied by electron microscopy and atomic force microscopy.

Etching of tracks of accelerated heavy ions in poly(ethylene terephthalate) and some physicochemical properties of track membranes

The features of etching of latent tracks of heavy ions in poly(ethylene terephthalate) up to pore formation were investigated. It was found that the etching process included the following stages: (1) electrolyte penetration into the pores due to capillary forces and removal of monomeric radiolysis products; (2) swelling of the cross-linked (due to secondary electrons) polymer areas around the tracks to give the gel layer; (3) removal of the gel layer and the formation of track membranes with a pore radius of 40–50 A. The radiation-chemical processes in polymers influence the physicochemical properties of the obtained membranes. The microrelief of the membrane surface was studied by atomic-force microscopy.