Istanbul needs to be protected and constantly monitored water resources due to its increasing population and the decrease in precipitation. This study aims to comprehensively reveal surface sediments collected from reservoirs that supply water to Istanbul concerning POPs (PAHs, PCBs, and OCPs) and heavy metals; to identify possible sources of PAHs, and conduct their ecological risk assessment. Pollution indices in this study were used as contamination degree (CD) contamination factor (CF), geoaccumulation index (Igeo), pollution load index (PLI) and Sediment Quality Guidelines (SQGs). Total PAH concentrations of surface sediments at the sampling points ranged from 46.29 ng/g (A7) to 403.9 ng/g (A15). Benzo(b)fluoranthene (5.647–59.42 ng/g), Pyrene (3.625–83.10 ng/g), Fluoranthene (3.363–66.48 ng/g), Phenanthrene (3.115–52.48 ng/g), Chrysene (3.532–43.98 ng/g), Naphthalene (6.606–36.20 ng/g), Benzo(g,h,i)perylene (3.316–41.73 ng/g) and Indeno(1,2,3-c,d)pyrene (3.453–38.84 ng/g) are the dominant PAH compounds. PAH pollution may be caused by the village-town settlements near the dam and the O7-D020 highway. Total OCP concentration ranged from 2.233 ng/g (A12) to 7.337 ng/g (A1), while total PCB concentration ranged from 0.246 ng/g (A13) to 3.708 ng/g (A1). The lowest total OCP and PCB concentrations were found in surface sediments taken from Kazandere, Papuçdere and Alibey Dam lakes. DDT p,p (0.072–5.177 ng/g) has the highest concentration among all sediment samples. While the most dominant OCP compounds in the samples were DDT p,p, DDE p,p and DDD p,p, HCH alpha, HCH beta, respectively, PCB 153, 138 and 180 were the highest detected PCB congeners in the same samples. Total heavy metal concentration varied from 77,812 mg/kg to 267,072 mg/kg. According to PAH diagnostic analysis, the surface sediments of Terkos, Büyükçekmece, Elmalı, Darlık, Sazlıdere, Alibey and Ömerli Dams were polluted by petrogenic sources, while the surface sediments of Kazandere and Papuçdere Dams were affected by pyrogenic sources. None of the levels of POPs in the samples exceeded the ERM values. Slight and moderate contamination of heavy metals, such as Pb and Zn, were present in most of the sampling points according to CD, CF, PLI and Igeo values. The quality criteria of heavy metals showed that almost all of the sampling points had Cd, Pb and Hg concentrations below the ERL values. The Ni concentrations at most of the sampling points significantly exceeded the ERM values. The concentrations of As, Cr, Cu and especially Ni and Zn exhibit a significant toxic risk to aquatic organisms to sediment quality criteria.
Read full abstract