Number Of Rinses Research Articles

Single and Serial Carbohydrate Mouth Rinsing Do Not Improve Yo-Yo Intermittent Recovery Test Performance in Soccer Players.

Carbohydrate (CHO) mouth rinsing seems to improve performance in exercises lasting 30-60min. However, its effects on intermittent exercise are unclear. It is also unknown whether serial CHO mouth rinses can promote additional ergogenic effects when compared with a single mouth rinse. The aim of this study was to evaluate the effect of single and serial CHO mouth rinses on Yo-Yo Intermittent Recovery Test Level 1 (Yo-Yo IR1) performance in soccer players. In a randomized, crossover, double-blind, placebo-controlled design, 12 male (18.9 ± 0.5years) soccer players performed eight serial mouth rinses under three different conditions: placebo solution only (noncaloric juice), seven placebo mouth rinses plus a single CHO mouth rinse (8% maltodextrin), or eight CHO mouth rinses (8-CHO). Following the final mouth rinse, individuals performed the Yo-Yo IR1 test to evaluate the maximal aerobic endurance performance measured via total distance covered. There were no differences in Yo-Yo IR1 performance between sessions (p = .32; single CHO mouth rinse (8% maltodextrin): 1,198 ± 289m, eight CHO mouth rinses: 1,256 ± 253m, placebo: 1,086 ± 284m). In conclusion, single and serial CHO mouth rinsing did not improve performance during the Yo-Yo IR1 for soccer players. These data suggest that CHO mouth rinsing is not an effective ergogenic strategy for intermittent exercise performance irrespective of the number of rinses.

Evaluation of dicamba retention in spray tanks and its impact on flue-cured tobacco

AbstractIn recent years, there has been increased use of dicamba due to the introduction of dicamba-resistant cotton and soybean in the United States. Therefore, there is a potential increase in off-target movement of dicamba and injury to sensitive crops. Flue-cured tobacco is extremely sensitive to auxin herbicides, particularly dicamba. In addition to yield loss, residue from drift or equipment contamination can have severe repercussions for the marketability of the crop. Studies were conducted in 2016, 2017, and 2018 in North Carolina to evaluate spray-tank cleanout efficiency of dicamba using various cleaning procedures. No difference in dicamba recovery was observed regardless of dicamba formulation and cleaning agent. Dicamba residue decreased with the number of rinses. There was no difference in dicamba residue recovered from the third rinse compared with residue from the tank after being refilled for subsequent tank use. Recovery ranged from 2% to 19% of the original concentration rate among the three rinses. Field studies were also conducted in 2018 to evaluate flue-cured tobacco response to reduced rates of dicamba ranging, from 1/5 to 1/10,000 of a labeled rate. Injury and yield reductions varied by environment and application timing. When exposed to 1/500 of a labeled rate at 7 and 11 wk after transplanting, tobacco injury ranged from 39% to 53% and 10% to 16% 24 days after application, respectively. The maximum yield reduction was 62%, with a 55% reduction in value when exposed to 112 g ha−1 of dicamba. Correlations showed significant relationships between crop injury assessment and yield and value reductions, with Pearson values ranging from 0.24 to 0.63. These data can provide guidance to growers and stakeholders and emphasize the need for diligent stewardship when using dicamba technology.

Surface Characterization and Antimicrobial Activity of Chitosan-Deposited DBD Plasma-Modified Woven PET Surface

In this work, a woven PET with an antimicrobial activity was prepared by depositing chitosan on its surface. Firstly, the hydrophilic property of the PET surface was achieved by a plasma treatment using dielectric barrier discharge (DBD). The hydrophilic property of the PET surface was characterized by wickability and contact angle measurements. The XPS analysis revealed an increment of oxygen-containing polar groups, such as C–O and O–C=O, on the PET surface after the plasma treatment, resulting in an enhanced hydrophilic property. The plasma-treated PET specimen was further deposited with chitosan by immersing in a chitosan acetate aqueous solution. The effects of temperature, chitosan concentration, and number of rinses on the amount of deposited chitosan on the PET surface were investigated. The disappearance of the above-mentioned polar groups from the PET surface was clearly observed after the chitosan deposition, indicating the involvement of these functional groups in interacting with the chitosan. The chitosan-deposited plasma-treated woven PET possessed an exceptionally high antimicrobial activity against both E. coli (gram-negative bacteria) and S. aureus (gram-positive bacteria).

Faecal indicator bacteria enumeration in beach sand: a comparison study of extraction methods in medium to coarse sands.

The absence of standardized methods for quantifying faecal indicator bacteria (FIB) in sand hinders comparison of results across studies. The purpose of the study was to compare methods for extraction of faecal bacteria from sands and recommend a standardized extraction technique. Twenty-two methods of extracting enterococci and Escherichia coli from sand were evaluated, including multiple permutations of hand shaking, mechanical shaking, blending, sonication, number of rinses, settling time, eluant-to-sand ratio, eluant composition, prefiltration and type of decantation. Tests were performed on sands from California, Florida and Lake Michigan. Most extraction parameters did not significantly affect bacterial enumeration. anova revealed significant effects of eluant composition and blending; with both sodium metaphosphate buffer and blending producing reduced counts. The simplest extraction method that produced the highest FIB recoveries consisted of 2 min of hand shaking in phosphate-buffered saline or deionized water, a 30-s settling time, one-rinse step and a 10 : 1 eluant volume to sand weight ratio. This result was consistent across the sand compositions tested in this study but could vary for other sand types. Method standardization will improve the understanding of how sands affect surface water quality.

Optimal conditions for the removal of house dust mite, dog dander, and pollen allergens using mechanical laundry

Mechanical laundry is an effective tool for the environmental control of allergens, but the optimal conditions for removing allergens are not yet clear. To evaluate the optimal conditions of mechanical laundry for the removal of house dust mite (HDM), dog dander, and pollen allergens. The 4 washing modes of 30 degrees C (86 degrees F), 40 degrees C (104 degrees F), 60 degrees C (140 degrees F), and steam water (SW) with detergent were evaluated. Allergen removal performance was assayed using a 2-site enzyme-linked immunosorbent assay (ELISA) or an ELISA inhibition test. Using the 30 degrees C and 40 degrees C washing modes, only 6.5% and 9.6% of Dermatophagoides farinae, respectively, were killed. However, using the 60 degrees C and SW washing modes, all HDMs were killed. The amounts of Der f 1 remaining after the 30 degrees C, 40 degrees C, 60 degrees C, and SW washing modes were 26.8%, 2.4%, 1.3%, and 0.6%, respectively, with unmanipulated contaminated sheets. The effects of rinse on Der f 1 levels after the 30 degrees C washing were greater compared with those after the 40 degrees C, 60 degrees C, and SW modes. The amounts of Can f 1 in the extractions after washing were 0.3% to 1.3% for all modes, and all extracts, even without a rinse, did not inhibit specific IgE binding to dog allergens according to ELISA. The remaining pollen allergen levels after washing were lower in the 60 degrees C and SW modes than in the lower temperature modes. However, the levels did not differ among the various washing modes after rinsing once. Water temperature and number of rinses are critical factors for the removal of HDM, dog dander, and pollen allergens.

Microemulsion Formation and Detergency with Oily Soil: IV. Effect of Rinse Cycle Design

AbstractThe objective of this work was to apply a microemulsion‐based formulation for the removal of motor oil in laundry detergency at low salinity. To produce the desired phase behavior, three surfactants were used: alkyl diphenyl oxide disulfonate (ADPODS), sodium dioctyl sulfosuccinate (AOT) and sorbitan monooleate (Span 80). The mixed surfactant system of 1.5% ADPODS, 5% AOT and 5% Span 80 (13 parts ADPODS, 43.5 parts AOT, and 43.5 parts Span 80 of the total actives) was found to form a middle phase microemulsion (Type III) at a relatively low salinity of 2.83% NaCl. When this formulation was diluted, detergency performance increased with increasing total surfactant concentration and leveled off above about 0.1% total actives on the three types of fabrics studied (pure cotton, 65/35 polyester/cotton blend, and pure polyester). Detergency was found to improve with increasing hydrophilicity of the fabric with cotton being cleanest after washing and polyester the most difficult to clean. To achieve a specified oil removal, less rinse water can be used if a higher number of lower‐volume rinses are employed. An interesting characteristic of microemulsion‐based formulations is that a substantial fraction of oil removal occurs during the rinse cycle. In this work, this removal is shown to be due to the low oil/water interfacial tension during initial rinsing and is therefore strongly correlated to residual surfactant concentration in the rinse steps. As a result, the number of rinses and the volume of water per rinse can profoundly affect detergency in these systems.

Ozone in the Laundry Industry—Practical Experiences in the United Kingdom

Since the early 1990s, the use of ozone in many commercial and industrial laundering applications has been evolving rapidly. Ozone allows washing to be conducted using cold water, thereby saving considerable heat energy and water consumption. Additionally, ozone enhances the wash process, resulting in a significant reduction in detergent dosage and number of rinses, thus saving water. Ozone/cold water cycles are gentler to fabrics, thus extending linen life. Finally, ozone/cold water laundering is beneficial for effluents, resulting in reductions in COD (chemical oxygen demand). Microorganisms are destroyed effectively in ozone-wash waters, and washing and drying cycles are shorter, thus saving labor. In this paper, the authors describe some specific case studies at commercial laundering installations in the UK, whereby the users of ozone have reaped major benefits, including enhanced microorganism kills/inactivation and significant cost savings.

Tissue Processing Practices in Central Hospital Pathology Laboratories in Finland

Tissue processing procedure of 20 central hospital pathology laboratories in Finland were compared as part of a national quality assessment program. Parameters examined included: solutions used in the tissue processor, frequency with which solutions were changed, processing time, number of rinses, agitation of specimens, use of vacuum, and different paraffin temperatures. The most significant differences among laboratories were the number of rinses and processing time, which varied by 1–9 hr. (The J Histotechnol 21:253–255, 1998)

Tissue Processing Practices in Central Hospital Pathology Laboratories in Finland

Tissue processing procedure of 20 central hospital pathology laboratories in Finland were compared as part of a national quality assessment program. Parameters examined included: solutions used in the tissue processor, frequency with which solutions were changed, processing time, number of rinses, agitation of specimens, use of vacuum, and different paraffin temperatures. The most significant differences among laboratories were the number of rinses and processing time, which varied by 1–9 hr. (The J Histotechnol 21:253–255, 1998)

Evolution of Trypsin Inhibitor Activity during Germination of Lentils

The effect of light and seed rinsing during the germination of lentil seeds (Lens culinaris var. Vulgaris cv. Magda-20) on trypsin inhibitor activity (TIA) has been studied. TIA decreased progressively during germination, while hydration grade and light exposure had less influence on TIA. In general, there was no significant change in TIA after 3 days of germination, except when seeds were rinsed only once and the experiment was conducted in the dark, showing a 10% TIA decrease. Six-day germination produced TIA decreases from 7% to 18%. In this case, the number of rinses had no significant effect on the final TIA, but the activity of protease inhibitors was significantly higher in seeds illuminated for 6 h per day. Maximal TIA decreases were found in seeds germinated in darkness and rinsed daily. Under these optimum conditions, TIA first decreased slowly (12% loss of this activity after 6 days) followed by a faster decrease (up to 45% of control seeds values) after 10 days of germination.

An intelligent washing machine for the evaluation of laundry detergents

AbstractA computer‐controlled washer can be programmed to evaluate automatically a large number of washing compositions for soil removal. Variable amounts of as many as six different detergent components are added with metering pumps. A continuous roll of soiled cloth passes through a washer and past a reflectance meter onto a take‐up reel. Washing action is provided by a vertical reciprocating shaft attached to a plate which rubs on the fabric while tension is maintained by a spring‐loaded roller. The length of the wash, number of rinses and addition of components is controlled by the computer program. Upon completion of the wash and rinse cycle, the fabric is advanced about 10 cm. Washed areas appear as lighter colored bands on the fabric. In one mode of operation a large factorial experiment is programmed in advance. After an initial calibration of metering pumps the apparatus runs unattended. In another mode, the computer receives feedback from the reflectance meter and a simplex procedure is used to determine the direction of maximum cleaning. Following the execution of a small number of initially programmed washes, the computer selects the succeeding wash compositions.