Influence Of Ultrashort Pulses Research Articles

Influence of ultrashort pulses on resonantly driven systems

The influence of ultrashort low-frequency laser pulses of different intensities and pulse lengths on the dynamics of a resonantly driven atomic system is investigated theoretically. We demonstrate the periodical dependence of the total ionization rate on the appearance time of a strong few-cycle laser pulse. By depleting the excited state, the intense short pulse not only resets the Rabi oscillations, but also introduces a time shift that is proportional to the pulse length. This time shift can be employed to determine the ultrashort pulse length. In the case of ultrashort pulses with lower intensities, we observe side-bands in the two-photon ionization spectrum, whose intensities vary periodically with the appearance time of the pulse. This can be utilized to measure the period of Rabi oscillations. We have developed an S-matrix theory of two-colour ionization which can explain some of the observations of our numerical calculations. Furthermore, we have studied the high harmonic generation spectra as well as the attosecond pulses generated from the high harmonics. We show that the Rabi oscillation can be used to alter the ionization rate within laser sub-cycles and therefore select different quantum trajectories in the high harmonics generation.

Development of Ultra-Short Pulse Power Supply Applicable to Micro-ECM

A nanosecond pulse power supply for micro-ECM (Electrochemical Machining) has been developed, and the minimum pulse on-time is 50 ns. After the influence of ultra-short pulse on micro-ECM was analyzed, complementary chopper circuit was presented to avoid waveform distortion, which can achieve higher pulse frequency. A fast protect circuit was designed, and its response time is less than 5μs, which can avoid damaging workpiece and electrical components by switching off machining voltage and step motor as soon as a short circuit was detected. A series of ECM experiments using the power supply have been carried out, and results of test have proved that high frequency, short pulse width power supply helps to achieve better quality surface, higher machining accuracy.