Influence Of Light Attenuation Research Articles

Modeling of surface waves in photo-responsive viscoelastic liquid crystal thin films under a moving light source

In this paper we present a computational model to simulate surface waves on photo-responsive liquid crystal thin films under dynamic illumination. The influence of light attenuation is included to model the dynamic photo-mechanical response as a result of the forward (trans to cis) and the backward (cis to trans) isomerization of the embedded azobenzene molecules. The viscoelastic nature of the liquid crystal films is also estimated and incorporated in this study. The temporal response of the material under static spot illumination is analyzed first to understand the underlying mechanisms behind the observed response. The relation between the fraction of transformed molecules and the macroscopic light induced strains and stresses through the thickness is investigated to establish the significance of light attenuation. Subsequently, the model liquid crystal film is exposed to a rectangular illumination waveform to simulate a moving light source and thereby generate surface waves. Results are presented that relate the wave attributes, (i.e., the amplitude, frequency and phase lag) to the time scales associated with the moving light source, the molecular trans-cis isomerization reaction and the viscoelastic response of the material. A design guideline for producing surface waves with specific features (amplitude, phase) is presented.

Absorption and scattering effects of Maalox, chlorophyll, and sea salt on a micro-LED-based underwater wireless optical communication [Invited

In this work, a blue gallium nitride (GaN) micro-light-emitting-diode (micro-LED)-based underwater wireless optical communication (UWOC) system was built, and UWOCs with varied Maalox, chlorophyll, and sea salt concentrations were studied. Data transmission performance of the UWOC and the influence of light attenuation were investigated systematically. Maximum data transmission rates at the distance of 2.3 m were 933, 800, 910, and 790 Mbps for experimental conditions with no impurity, 200.48 mg/m3 Maalox, 12.07 mg/m3 chlorophyll, and 5 kg/m3 sea salt, respectively, much higher than previously reported systems with commercial LEDs. It was found that increasing chlorophyll, Maalox, and sea salt concentrations in water resulted in an increase of light attenuation, which led to the performance degradation of the UWOC. Further analysis suggests two light attenuation mechanisms, e.g., absorption by chlorophyll and scattering by Maalox, are responsible for the decrease of maximum data rates and the increase of bit error rates. Based on the absorption and scattering models, excellent fitting to the experimental attenuation coefficient can be achieved, and light attenuation by absorption and scattering at different wavelengths was also investigated. We believe this work is instructive apply UWOC for practical applications.

Characteristics of III-nitride based laser diode employed for short range underwater wireless optical communications

An off-the-shelf green laser diode (LD) was measured to investigate its temperature dependent characteristics. Performance of the device was severely restricted by rising temperature in terms of increasing threshold current and decreasing modulation bandwidth. The observation reveals that dynamic characteristics of the LD is sensitive to temperature. Influence of light attenuation on the modulation bandwidth of the green LD was also studied. The impact of light attenuation on the modulation bandwidth of the LD in short and low turbid water channel was not obvious while slight difference in modulation bandwidth under same injection level was observed between water channel and free space even at short range.

The influence of light attenuation on the biogeomorphology of a marine karst cave: A case study of Puerto Princesa Underground River, Palawan, the Philippines

Karst caves are unique biogeomorphological systems. Cave walls offer habitat for microorganisms which in-turn have a geomorphological role via their involvement in rock weathering, erosion and mineralisation. The attenuation of light with distance into caves is known to affect ecology, but the implications of this for biogeomorphological processes and forms have seldom been examined. Here we describe a semi-quantitative microscopy study comparing the extent, structure, and thickness of biocover and depth of endolithic penetration for samples of rock from the Puerto Princesa Underground River system in Palawan, the Philippines, which is a natural UNESCO World Heritage Site.Organic growth at the entrance of the cave was abundant (100% occurrence) and complex, dominated by phototrophic organisms (green microalgae, diatoms, cyanobacteria, mosses and lichens). Thickness of this layer was 0.28±0.18mm with active endolith penetration into the limestone (mean depth=0.13±0.03mm). In contrast, phototrophs were rare 50m into the cave and biofilm cover was significantly thinner (0.01±0.01mm, p<0.000) and spatially patchy (33% occurrence). Endolithic penetration here was also shallower (<0.01mm, p<0.000) and non-uniform. Biofilm was found 250m into the cave, but with a complete absence of phototrophs and no evidence of endolithic bioerosion.We attribute these findings to light-induced stress gradients, showing that the influence of light on phototroph abundance has knock-on consequences for the development of limestone morphological features. In marine caves this includes notches, which were most well-developed at the sheltered cave entrance of our study site, and for which variability in formation rates between locations is currently poorly understood.

Influence of light attenuation on primary production in a shallow sand-pit lake

(1991). Influence of light attenuation on primary production in a shallow sand-pit lake. SIL Proceedings, 1922-2010: Vol. 24, No. 3, pp. 1536-1542.