Implementation Of Quantum Repeaters Research Articles

Frequency-multiplexed Hong-Ou-Mandel interference

The implementation of quantum repeaters needed for long-distance quantum communication requires the generation of quantum entanglement distributed among the elementary links. These entanglements must be swapped among the quantum repeaters through Bell-state measurements. This study aims to improve the entanglement generation rate by frequency multiplexing the Bell-state measurements. As a preliminary step of the frequency-multiplexed Bell-state measurements, three frequency modes are mapped to a temporal mode by an atomic frequency comb prepared in $\mathrm{Pr^{3+}}$ ion-doped $\mathrm{Y_2SiO_5}$ crystals using a weak coherent state, and Hong-Ou-Mandel interference, which is a measure of the indistinguishability of two inputs, is observed in each frequency mode by coincidence detection. The visibility for all the modes was 40%-42% (theoretically up to 50%). Furthermore, we show that a mixture of different modes is avoided. The present results are connected to frequency-selective Bell-state measurements and therefore frequency-multiplexed quantum repeaters.

Design and Implementation of Quantum Repeaters: Insights on Quantum Entanglement Purification

Design and Implementation of Quantum Repeaters: Insights on Quantum Entanglement Purification

Optical barium ion qubit

We demonstrate an optical single qubit based on 6S1/2 to 5D5/2 quadrupole transition of a single Ba+ ion operated by diode based lasers only. The resonance wavelength of the 6S1/2 to 5D5/2 quadrupole transition is about 1762 nm which suitably falls close to the U-band of the telecommunication wavelength. Thus this qubit is a naturally attractive choice towards implementation of quantum repeater or quantum networks using existing telecommunication networks. We observe continuous bit-flip oscillations at a rate of about 250 kHz which is fast enough for the qubit operation as compared to the measured coherence time of over 3 ms. We also present a technique to quantify the bit-flip error in each qubit NOT gate operation.

Graphene-based qubits in quantum communications

We explore the potential application of graphene-based qubits in photonic quantum communications. In particular, the valley pair qubit in double quantum dots of gapped graphene is investigated as a quantum memory in the implementation of quantum repeaters. For the application envisioned here, our work extends the recent study of the qubit (Wu et al., arXiv: 1104.0443; Phys. Rev. B 84, 195463 (2011)) to the case where the qubit is placed in a normal magnetic field-free configuration. It develops, for the configuration, a method of qubit manipulation, based on a unique AC electric field-induced, valley-orbit interaction-derived mechanism in gapped graphene. It also studies the optical response of graphene quantum dots in the configuration, in terms of valley excitation with respect to photonic polarization, and illustrates faithful photon \leftrightarrow valley quantum state transfers. This work suggests the interesting prospect of an all-graphene approach for the solid state components of a quantum network, e.g., quantum computers and quantum memories in communications.