Closed-loop DC-DC Converter Research Articles

Comparison of solar based closed loop DC-DC converter using PID and ANN control for shunt motor drive

<p>This paper explained details of Comparison of solar based closed loop DC -DC converter using PID and ANN Control for Shunt motor drive. Solar panel output is given to full bridge converter, stepup transformer, full wave converter, ∏ filter and Shunt motor drive are connected.Comparator compare the set value and the output signal of the motor produce a signal, based on the signal, full wave conveter produce the voltage to run the motor, Speed of motor,Torque and Armature current,Rise time,Peak time, Settling time and Steady state error are measured and evaluated by experimental.A circuit operation and simulation designed for a 1000 RPM speed of shunt motor arrived and tested.</p>

DESIGN AND IMPLEMENTATION OF CLOSED LOOP LCL-T RESONANT DC-TO-DC CONVERTER USING LOW COST EMBEDDED CONTROLLER

The aim of this study is to simulate and implement open loop and closed loop controlled DC-DC converter for stand-alone wind energy system. Wind turbines, however, are not always very efficient in the wind speeds that are most common to a region. Typically, wind energy systems are designed to be highly efficient in high wind speed and have a cut-off wind speed- below which no energy is captured. In remote locations where wind energy is used for battery charging, the energy lost below the cut-off wind speed could be used for trickle charging or maintaining a battery’s fully charged state. Wind turbines are most efficient when they are operated at one specific Tip-Speed to Wind-Speed Ratio (TSR). Therefore, for the efficient capture of wind power, turbine speed should be controlled to follow the ideal TSR, with an optimal operating point, which is different for every wind speed In this system, the DC-DC converter in the DC link with a constant dc voltage to the load, a DC-DC converter will allow the voltage at the output of a diode bridge rectifier to be controlled. In low wind speed conditions, the voltage may be lowered to prevent the dc link from reverse biasing the diode rectifier. Under high wind speed condition, the voltage may be increased, reducing I2R losses. In addition, adjusting the voltage on the dc rectifier will change the generator terminal voltage and thereby provide control over the current flowing out of the generator. The LCL-T resonant inverter system for both open loop and closed loop DC-to-DC converter systems are simulated using MATLAB simulink power system blocks. This converter has advantages like reduced transformer size, reduced filter size and current source characteristics. The simulation studies indicate that LCL-T type for open and closed loop DC-DC converter can be used with stand-alone wind generator. Constant voltage can be maintained at the output of DC-to-DC converter by using a PWM rectifier at the output. Embedded controlled DC to DC converter is fabricated and it is tested.

An Analysis Method of Operation State for Boost Converter with Voltage Feedback Control

Abstract When system parameters were adjusted, some instability phenomenon could occur in closed-loop DC-DC converter. For improving the stability of converter system, an analysis method of operation state for converter was presented based on the discrete model of continuous conduction mode(CCM) Boost converter with voltage feedback control. This method can avoid fussy derivative operation. The steady equation of CCM Boost converter was deduced and the system parameters condition on which closed-loop instability phenomenon would occur were analyzed, the condition is appropriate to high frequency Boost converter. Corresponding simulation results were given in this paper.