Blue Copper Azurin Research Articles

Two-dimensional ultrafast transient absorption spectrograph covering deep-ultraviolet to visible spectral region optimized for biomolecules

We report on the implementation of a multi-kHz single-shot referenced non-coherent two-dimensional UV spectrograph based on conventional pump-probe geometry. It has the capability to cover a broad spectral region in excitation from 270-to-380 nm and in the detection from 270-to-390 nm and 320-to-720 nm. Other setups features are: an unprecedented time resolution of 33 fs (standard deviation); signals are photometrically corrected; a single-shot noise of <1 mOD. It has the capability to operate with sample volumes as small as few μl which is an accomplishment in studying biological or biomimetic systems. To show its performances and potentials, we report two preliminary studies on the photophysics of phenanthrenes hosted in a multichromophoric antenna system and of aromatic amino acids in a blue-copper azurin.

The Role of Metal Ions in the Electron Transport through Azurin-Based Junctions

We studied the coherent electron transport through metal–protein–metal junctions based on a blue copper azurin, in which the copper ion was replaced by three different metal ions (Co, Ni and Zn). Our results show that neither the protein structure nor the transmission at the Fermi level change significantly upon metal replacement. The discrepancy with previous experimental observations suggests that the transport mechanism taking place in these types of junctions is probably not fully coherent.

Tuning Structure and Dynamics of Blue Copper Azurin Junctions via Single Amino-Acid Mutations.

In the growing field of biomolecular electronics, blue-copper Azurin stands out as one of the most widely studied protein in single-molecule contacts. Interestingly, despite the paramount importance of the structure/dynamics of molecular contacts in their transport properties, these factors remain largely unexplored from the theoretical point of view in the context of single Azurin junctions. Here we address this issue using all-atom Molecular Dynamics (MD) of Pseudomonas Aeruginosa Azurin adsorbed to a Au(111) substrate. In particular, we focus on the structure and dynamics of the free/adsorbed protein and how these properties are altered upon single-point mutations. The results revealed that wild-type Azurin adsorbs on Au(111) along two well defined configurations: one tethered via cysteine groups and the other via the hydrophobic pocket surrounding the Cu. Surprisingly, our simulations revealed that single amino-acid mutations gave rise to a quenching of protein vibrations ultimately resulting in its overall stiffening. Given the role of amino-acid vibrations and reorientation in the dehydration process at the protein-water-substrate interface, we suggest that this might have an effect on the adsorption process of the mutant, giving rise to new adsorption configurations.

Mechanical Deformation and Electronic Structure of a Blue Copper Azurin in a Solid-State Junction.

Protein-based electronics is an emerging field which has attracted considerable attention over the past decade. Here, we present a theoretical study of the formation and electronic structure of a metal-protein-metal junction based on the blue-copper azurin from pseudomonas aeruginosa. We focus on the case in which the protein is adsorbed on a gold surface and is contacted, at the opposite side, to an STM (Scanning Tunneling Microscopy) tip by spontaneous attachment. This has been simulated through a combination of molecular dynamics and density functional theory. We find that the attachment to the tip induces structural changes in the protein which, however, do not affect the overall electronic properties of the protein. Indeed, only changes in certain residues are observed, whereas the electronic structure of the Cu-centered complex remains unaltered, as does the total density of states of the whole protein.

Redesigning the blue copper azurin into a redox-active mononuclear nonheme iron protein: preparation and study of Fe(II)-M121E azurin.

Much progress has been made in designing heme and dinuclear nonheme iron enzymes. In contrast, engineering mononuclear nonheme iron enzymes is lagging, even though these enzymes belong to a large class that catalyzes quite diverse reactions. Herein we report spectroscopic and X-ray crystallographic studies of Fe(II)-M121E azurin (Az), by replacing the axial Met121 and Cu(II) in wild-type azurin (wtAz) with Glu and Fe(II), respectively. In contrast to the redox inactive Fe(II)-wtAz, the Fe(II)-M121EAz mutant can be readily oxidized by Na2IrCl6, and interestingly, the protein exhibits superoxide scavenging activity. Mössbauer and EPR spectroscopies, along with X-ray structural comparisons, revealed similarities and differences between Fe(II)-M121EAz, Fe(II)-wtAz, and superoxide reductase (SOR) and allowed design of the second generation mutant, Fe(II)-M121EM44KAz, that exhibits increased superoxide scavenging activity by 2 orders of magnitude. This finding demonstrates the importance of noncovalent secondary coordination sphere interactions in fine-tuning enzymatic activity.

Copper–sulfenate complex from oxidation of a cavity mutant ofPseudomonas aeruginosaazurin

Metal-sulfenate centers are known to play important roles in biology and yet only limited examples are known due to their instability and high reactivity. Herein we report a copper-sulfenate complex characterized in a protein environment, formed at the active site of a cavity mutant of an electron transfer protein, type 1 blue copper azurin. Reaction of hydrogen peroxide with Cu(I)-M121G azurin resulted in a species with strong visible absorptions at 350 and 452 nm and a relatively low electron paramagnetic resonance gz value of 2.169 in comparison with other normal type 2 copper centers. The presence of a side-on copper-sulfenate species is supported by resonance Raman spectroscopy, electrospray mass spectrometry using isotopically enriched hydrogen peroxide, and density functional theory calculations correlated to the experimental data. In contrast, the reaction with Cu(II)-M121G or Zn(II)-M121G azurin under the same conditions did not result in Cys oxidation or copper-sulfenate formation. Structural and computational studies strongly suggest that the secondary coordination sphere noncovalent interactions are critical in stabilizing this highly reactive species, which can further react with oxygen to form a sulfinate and then a sulfonate species, as demonstrated by mass spectrometry. Engineering the electron transfer protein azurin into an active copper enzyme that forms a copper-sulfenate center and demonstrating the importance of noncovalent secondary sphere interactions in stabilizing it constitute important contributions toward the understanding of metal-sulfenate species in biological systems.

Modulating the Copper-Sulfur Interaction in Type 1 Blue Copper Azurin by Replacing Cys112 with Nonproteinogenic Homocysteine.

The Cu-SCys interaction is known to play a dominant role in defining the type 1 (T1) blue copper center with respect to both its electronic structure and electron transfer function. Despite this importance, its role has yet to be probed by mutagenesis studies without dramatic change of its T1 copper character. We herein report replacement of the conserved Cys112 in azurin with the nonproteinogenic amino acid homocysteine. Based on electronic absorption, electron paramagnetic resonance, and extended x-ray absorption fine structural spectroscopic studies, this variant displays typical type 1 copper site features. Surprisingly, instead of increasing the strength of the Cu-sulfur interaction by the introduction of the extra methylene group, the Cys112Hcy azurin showed a decrease in the covalent interaction between SHcy and Cu(II) when compared with the WT SCys-Cu(II) interaction. This is likely due to geometric adjustment of the center that resulted in the copper ion moving out of the trigonal plane defined by two histidines and one Hcy and closer to Met121. These structural changes resulted in an increase of reduction potential by 35 mV, consistent with lower Cu-S covalency. These results suggest that the Cu-SCys interaction is close to being optimal in native blue copper protein. It also demonstrates the power of using nonproteinogenic amino acids in addressing important issues in bioinorganic chemistry.

Incorporation of the red copper nitrosocyanin binding loop into blue copper azurin

Loop-directed mutagenesis was applied to the blue copper protein azurin to replace its copper binding loop with that from the red copper protein nitrosocyanin. A ten amino acid long loop that provides three of the four copper ligands from nitrosocyanin was incorporated into azurin to make a variant called NC-azurin. The chimeric protein displayed a red color, and UV-vis absorption and EPR spectra that closely resembled those of the loop parent, nitrosocyanin. We added the fourth ligand from nitrosocyanin into NC-azurin, a carboxylate-containing amino acid, but the proteins had altered stability and spectroscopic properties that did not resemble those of either parent copper protein. The loop alone, however, was enough to impart red copper site characteristics to the NC-azurin protein. Finally, the reduction potential of the variant was found to be between the reduction potentials of the parent proteins and about 50mV below that of wild-type azurin.

Axial Methionine Has Much Less Influence on Reduction Potentials in a CuA Center than in a Blue Copper Center

The role of the highly conserved axial methionine of the purple CuA center in an engineered CuA azurin on modulating the reduction potentials of the copper center was investigated by a systematic replacement of the methionine with glutamate, aspartate, and leucine. In contrast to the same substitutions in the structurally related blue copper azurin, much smaller changes in reduction potential were observed in the CuA azurin upon replacing the methionine ligand with negatively charged Glu (-8 mV) and Asp (-5 mV) and more hydrophobic Leu (+16 mV). These findings are important in understanding the different roles of the two cupredoxins. The diamond core Cu2S2(Cys) structure of the CuA is much more resistant to variations of axial ligand interactions than the distorted tetrahedral structure of the blue copper protein. This difference may translate into a much wider range of reduction potentials (>1000 mV) for blue copper proteins that transfer electrons to a variety of partners in many different biological systems and a much narrower range of reduction potentials (<40 mV) for CuA proteins where a small difference in reduction potentials between the CuA and its redox partners is required.

Enhanced rate of intramolecular electron transfer in an engineered purple CuA azurin.

The recent expression of an azurin mutant where the blue type 1 copper site is replaced by the purple CuA site of Paracoccus denitrificans cytochrome c oxidase has yielded an optimal system for examining the unique electron mediation properties of the binuclear CuA center, because both type 1 and CuA centers are placed in the same location in the protein while all other structural elements remain the same. Long-range electron transfer is induced between the disulfide radical anion, produced pulse radiolytically, and the oxidized binuclear CuA center in the purple azurin mutant. The rate constant of this intramolecular process, kET = 650 +/- 60 s-1 at 298 K and pH 5.1, is almost 3-fold faster than for the same process in the wild-type single blue copper azurin from Pseudomonas aeruginosa (250 +/- 20 s-1), in spite of a smaller driving force (0.69 eV for purple CuA azurin vs. 0.76 eV for blue copper azurin). The reorganization energy of the CuA center is calculated to be 0.4 eV, which is only 50% of that found for the wild-type azurin. These results represent a direct comparison of electron transfer properties of the blue and purple CuA sites in the same protein framework and provide support for the notion that the binuclear purple CuA center is a more efficient electron transfer agent than the blue single copper center because reactivity of the former involves a lower reorganization energy.

Tunneling matrix element in Ru-modified blue copper proteins: pruning the protein in search of electron transfer pathways

We investigate with semi-empirical extended Hückel theory calculations the tunneling matrix element for electron transfer in three ruthenium-modified blue copper azurin molecules from the bacterium Pseudomonas aeruginosa which have been recently synthesized and studied experimentally by Gray and co-workers. All of the atoms in the protein can be included in the calculations with the method of transition amplitudes that has been developed recently. Our particular focus here, however, is to develop procedures that create a truncated protein much smaller than the initial 2000 atom one, the aim being to retain only those amino acids that are important to the electron tunneling mechanism. Such a procedure, which we refer to as ‘pruning’, is useful, first because it reduces the size of the problem, perhaps allowing for more accurate techniques to be used on the truncated protein, and second because it allows for the identification of the regions in the protein in which the tunneling electron is localized. The pruning procedures enable us to reduce the number of atoms required in an extended Hückel theory analysis of the tunneling mechanism by approximately a factor of 10 over that in the original protein.