Abstract
Abstract For detecting powder-binder separation in the L-shaped mould, the L-shaped and cuboid SiC green bodies were scanned by using X-ray tomography. Then, a quantitative relation between the gray values in the reconstructed images and the solid loadings was determined. Next, the solid loading distribution of the L-shaped green bodies was discussed. In the analyzed samples, the binder accumulation area were mainly found near the gate and mould boundary, and the high powder content area formed in the middle lower part of the mould. Finally, the effects of three injection parameters (injection speed, temperature and injection pressure) on the powder-binder separation during mould filling were analyzed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.