Abstract

Many X-ray accreting pulsars have a soft excess below 10 keV. This feature has been detected also in faint sources and at low luminosity levels, suggesting that it is an ubiquitous phenomenon. In the case of the high luminosity pulsars (Lx > 10^36 erg/s), the fit of this component with thermal emission models usually provides low temperatures (kT < 0.5 keV) and large emission regions (R > a few hundred km); for this reason, it is referred to as a `soft' excess. On the other hand, we recently found that in persistent, low-luminosity (Lx ~ 10^34 erg/s) and long-period (P > 100 s) Be accreting pulsars the observed excess can be modeled with a rather hot (kT > 1 keV) blackbody component of small area (R < 0.5 km), which can be interpreted as emission from the NS polar caps. In this paper we present the results of a recent XMM-Newton observation of the Galactic Be pulsar RX J0440.9+4431, which is a poorly studied member of this class of sources. We have found a best-fit period P = 204.96(+/-0.02) s, which implies an average pulsar spin-down during the last 13 years, with dP/dt ~ 6x10^(-9) s/s. The estimated source luminosity is Lx ~ 8x10^(34) erg/s: this value is higher by a factor < 10 compared to those obtained in the first source observations, but almost two orders of magnitude lower than those measured during a few outbursts detected in the latest years. The source spectrum can be described with a power law plus blackbody model, with kTbb = 1.34(+/-0.04) keV and Rbb = 273(+/-16) m, suggesting a polar-cap origin of this component. Our results support the classification of RX J0440.9+4431 as a persistent Be/NS pulsar, and confirm that the hot blackbody spectral component is a common property of this class of sources.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.