Abstract
This paper presents the application of the weight function method for the calculation of elastic T-stress for semi-elliptical surface cracks. First, the weight function method for the calculation of T-stress previously developed for two-dimensional crack problems was extended for the T-stress calculation for three-dimensional crack problems. Then, the T-stress weight functions for the deepest point (corresponding to the parametric angle ϕ = 90°) and for any general point (5° ≤ ϕ < 90°) along the crack front of semi-elliptical surface cracks in finite-thickness plates for wide ranges of crack aspect ratios a/c and relative depths a/t were derived. The resulting weight functions were validated using available finite element results for non-linear stress fields and remote tension and bending cases, and very good agreement was achieved. The weight functions are suitable for the calculation of the T-stress under complex loading conditions for any general point (5° ≤ ϕ ≤ 90°) of surface cracks with wide ranges of aspect ratios, 0 ≤ a/c ≤ 1, and relative depths, 0 ≤ a/t ≤ 0.8.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: The Journal of Strain Analysis for Engineering Design
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
