Wear and mechanical properties of composite resins consisting of different filler particles

Abstract

To investigate the effects of different fillers and their contents on the wear of composite resins, four composites (CS: non-porous spherical silica, AS: porous spherical silica, AZ: porous spherical zirconium silicate, and IS: non-porous irregular-shaped silica) were experimentally prepared using different fillers (CS, AZ, AS and IS). Simulated occlusal wear and toothbrush wear were evaluated for these composites and their worn surfaces were observed. The mechanical properties (flexural strength, elastic modulus and hardness) of these composites were determined to examine the relationships between wear and these mechanical properties. CS showed the highest occlusal wear, but the lowest toothbrush wear among four composites. AS and AZ had lower occlusal wear than CS and IS, while their toothbrush wear was higher than CS and close to that of IS. All composites showed increase in the occlusal wear as filler content increased. CS and IS showed decrease in the toothbrush wear as the filler content increased, whereas AS and AZ did not. The occlusal wear surfaces of CS and IS had concavities, while those of AZ and AS were relatively smooth with flattened filler. The toothbrush wear surfaces of CS and IS revealed the extrusion of filler from resin matrix, whereas those of AZ and AS were smooth with flattened filler. The toothbrush wear of CS and IS decreased as the mechanical properties increased, whereas those of AS and AZ did not. The occlusal wear of all composites increased as the mechanical properties increased, which would not reflect effects of these mechanical properties.