Veneer-wrapped steel columns: Proof-of-concept experimental and numerical investigations

Abstract

This paper presents and discusses the structural behaviour of a novel type of steel–timber composite column to be used in residential building applications. It consists of a circular hollow section wrapped by multiple beech veneer sheets and where the composite action is ensured by a structural bi-component glue applied over the contact surfaces. As part of a proof-of-concept study, five short and three long columns with lengths of 0.27 m and 2.00 m, respectively, were tested under vertical concentric load with fibres parallel to the load direction and inclined by 15°. The global response of the specimens in terms of load-displacement behaviour and failure modes was studied, along with localised strain measurements through strain gauges and a digital image correlation (DIC) system. Results showed a significant increase in buckling resistance due to the stiffness added by the veneer layers. Already with the still-moderate veneer layer thicknesses used in this study, an increase in strength of over 25 % could thus be achieved. This enhancement highlights the effectiveness of veneer wrapping in stabilizing the inner core and delaying the occurrence of flexural buckling failure. A 3D non-linear finite element model (FEM) validated these findings, showing a good correlation with experimental results in resistance and stiffness. A parametric study was conducted to explore different geometries and materials, thus creating an extended FEM-based database. A relatively good agreement with modest deviation between the FEM predictions and analytical formulations available in the European Standards was found, considering the appropriate introduction of the mechanical properties of timber.