Ultrasonic peening-waterjet composite surface modification of 7075-T6 aluminum alloy for residual stress release and transformation mechanism

Abstract

The release and transformation mechanism of residual stress contributes to the improvement of metal materials' processing and performance, enhancing their structural stability, surface integrity, and fracture resistance. This paper focuses on the Ultrasonic Impact Treatment-Solid Particle Entrainment by Waterjet (UIT-SPEWJ) composite surface modification of 7075-T6 aluminum alloy, investigating the effects of UIT-SPEWJ process parameters (jet pressure and target distance) on the alloy's surface quality, roughness, microhardness, residual stress, and the evolution mechanism of microstructure. The results indicate that the 7075-T6 aluminum alloy modified by UIT-SPEWJ mainly exhibits a "meteorite crater" effect, accompanied by significant smearing and ploughing phenomena. Surface roughness shows a trend of first decreasing and then increasing with the rise of jet pressure and target distance. The minimum surface roughness, 0.852 μm, is achieved at a jet pressure of 25 MPa and a target distance of 7.5 mm. The microhardness of the samples modified by UIT-SPEWJ gradually decreases from the surface to the substrate with increasing depth. The hardened layer depths of the samples UIT-SPEWJ-1–6 after modification are approximately 174 μm, 226 μm, 200 μm, 196 μm, 176 μm, and 172 μm, respectively. After UIT, SPEWJ, and UIT-SPEWJ surface modifications, the surface of 7075-T6 aluminum alloy mainly exhibits compressive residual stress (CRS). The surface residual stress σ_srs of samples modified by UIT and SPEWJ are approximately 195.161 and 215.752 MPa, respectively. The surface residual stresses of UIT-SPEWJ-1–6 samples are significantly improved to 277.089, 529.499, 393.615, 459.261, 368.084, and 220.635 MPa, respectively, with UIT-SPEWJ-2 sample having the highest surface residual stress, which is 2.7 and 2.4 times that of UIT and SPEWJ modified surfaces. Samples modified by UIT-SPEWJ present significant dislocation phenomena, and the precipitated phases mainly include the needle-like metastable phase η', as well as the equilibrium phase η (MgZn2) with a rod-like structure. At lower jet pressures and larger target distances, the 7075-T6 aluminum alloy exhibits a continuous PFZ with a size of approximately 12–23 nm. As jet pressure increases and target distance decreases, discontinuous grain boundary precipitate bands appear, sized around 8–17 nm. Moreover, when the jet pressure is 25 MPa and the target distance is 7.5 mm, the grain boundary precipitated phases are more dispersed.