Abstract
Transparent and conducting zinc oxide (ZnO) films have been prepared on glass substrates by atmospheric and low pressure chemical vapour deposition (CVD) using zinc acetylacetonate (Zn(C 5H 7O 2) 2) and various oxygen sources such as air, water (H 2O) and hydrogen peroxide (H 2O 2). A resistivity of (4–6) × 10 −3 Ω cm and an average transmittance above 80% in the visible range were obtained for undoped ZnO thin films prepared at a substrate temperature of 550°C using H 2O or H 2O 2. It was found that H 2O and H 2O 2, which include hydrogen, were better oxygen sources than an oxygen-containing gas such as air. The deposition rate of ZnO films was controlled by the Zn(C 5H 7O 2) 2 temperature. Al-doped ZnO films with a resistivity as low as 4.6 × 10 −3 Ω cm were prepared at a substrate temperature of 350°C by CVD at a low pressure of 60 Torr using aluminium acetylacetonate (Al(C 5H 7O 2) 3) as the dopant source.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.