Abstract
In bulk heterojunction (BHJ) organic solar cells (OSC), the photoactive layer morphology controls charge carrier generation, transport, and extraction. Obtaining the “optimum” morphology is often achieved by empiric optimization of processing conditions and post‐processing treatment. Better control over the morphology can be achieved by sequential photoactive layer‐by‐layer (LbL) deposition techniques, creating a pseudo‐bilayer OSC. Solvent additives can be used to modify the vertical component distribution, thereby enhancing OSC efficiency. However, the impact of solvent additives on device photophysics is often unclear. Here, the photophysics of LbL‐coated PM6/Y6 organic solar cells are reported. Enhanced power conversion efficiencies (PCEs) are observed when using 1‐chloronaphthalene (CN) as a solvent additive. Transient absorption (TA) spectroscopy indicates that the addition of 0.5% CN facilitates both exciton dissociation and charge separation, while excessive (>1%) use of CN causes fast geminate and non‐geminate charge recombination and consequently deteriorates device performance. The results outline routes to fine‐tune the morphology of LbL‐coated photoactive layers of OSCs and provide insight into the reasons for increased PCEs.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
