Abstract
Abstract We experimentally investigated the influence of the geometries of a modulated wave train on the vertical-bending and torsional moments acting on a container ship in bow-quartering sea conditions. We conducted a towing experiment with a hydro-structural container ship model in the Actual Sea Model Basin (ASMB) (80 m deep, 40 m wide, and 4.5 m deep) at the National Maritime Research Institute. The ship model is made of urethane foam and was designed to have similar vertical bending and torsional vibration mode shapes to an actual ship. A modulated wave train was generated in the ASMB by the higher-order spectral-method wave generation (HOSM-WG) method such that the maxim crest appeared at the center of the basin. The ship model was towed in the modulated wave train with a relative heading angle of 120 degrees. A series of tests was performed by varying the encounter timing of the ship model and the maximum crest of the modulated wave train. In the experiment, fiber-Bragg-grating strain gauges successfully measured whipping vibrations of the ship model due to a slamming impact. The experimental results revealed that the rear wave height Hr and the ratio of the rear and front wave heights Hr/Hf were the dominant parameters governing the maximum sagging and torsional moments of a ship in bow-quartering modulated wave trains.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
