Abstract
AbstractMicro milling operation is a fabrication process to create 3D parts from tens of micrometers to a few millimeters in size using a tool with diameter less than 1mm. Micro groove is one of the common features observed in the micro parts. The surface roughness of micro grooves plays an important role in their performance. Since most of the finishing processes could not be easily performed on the micro grooves, it is of extreme importance to find a relationship between micro milling parameters and the surface roughness profile. In this paper, in order to anticipate the profile and surface roughness of the groove floor a model is proposed based on the kinematic of cutting process and tool geometry. The effects of minimum chip thickness, elastic recovery, size effect and tool deflection are included in the model. Relationship between position of points on the floor surface of groove and kinematics of cutting process are derived. In next step, simulations of proposed model are performed in the ACIS environment. Finally, using the DOE method surface roughness is investigated stochastically. The simulated and measured surface roughnesses are compared together that confirm the validity of proposed model.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.