Abstract
In this work, we doped sputtered MoSe2 coatings with Ti to improve their mechanical and tribological properties. Mo-Se-Ti coatings were prepared onto steel discs by High Target Utilisation Sputtering (HiTUS). The Ti was in the range 7–31 at.%, which led to Se/Mo ratios of 1.7–2.7. The Mo-Se-Ti coatings possessed a polycrystalline structure for the lower Ti contents and became amorphous when Ti content was above approx. 18 at.%. The hardness of the initially soft (0.3 GPa) pure MoSe2 coatings was dramatically improved with Ti additions (up to 7.5 GPa). Sliding experiments confirmed excellent tribological properties: coefficient of friction values from 0.02 to 0.08 and very low wear rates (8×10-8mm3N-1m−1) of the Ti-containing coatings tested in the humid air at the loads in the range of 2–45 N. The outstanding self-lubricant properties of Mo-Se-Ti coatings were attributed to the transformation of the topmost amorphous part of the coating into crystalline MoSe2 tribofilm while preserving inner parts of the coating in as-deposited state ensuring good load-bearing capacity. There is strong experimental evidence that Ti has a gettering effect in the tribological contact, which protects MoSe2 tribofilm against oxidation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.