Abstract
This study aims to investigate the regional variations of trabecular morphological parameters and mechanical parameters of the femoral head, as well as to determine the relationship between trabecular morphological and mechanical parameters. Seven femoral heads from patients with fractured proximal femur were scanned using a micro-CT system. Each femoral head was divided into 12 sub-regions according to the trabecular orientation. One $$125\,\hbox {mm}^{3}$$ trabecular cubic model was reconstructed from each sub-region. A total of 81 trabecular models were reconstructed, except three destroyed sub-regions from two femoral heads during the surgery. Trabecular morphological parameters, i.e. trabecular separation (Tb.Sp), trabecular thickness (Tb.Th), specific bone surface (BS/BV), bone volume fraction (BV/TV), structural model index (SMI), and degree of anisotropy (DA) were measured. Micro-finite element analyses were performed for each cube to obtain the apparent Young’s modulus and tissue level von Mises stress distribution under 1 % compressive strain along three orthogonal directions, respectively. Results revealed significant regional variations in the morphological parameters ( $$P < 0.05$$ ). Young’s moduli along the trabecular orientation were significantly higher than those along the other two directions. In general, trabecular mechanical properties in the medial region were lower than those in the lateral region. Trabecular mechanical parameters along the trabecular orientation were significantly correlated with BS/BV, BV/TV, Tb.Th, and DA. In this study, regional variations of microstructural features and mechanical properties in the femoral head of patients with proximal femur fracture were thoroughly investigated at the tissue level. The results of this study will help to elucidate the mechanism of femoral head fracture for reducing fracture risk and developing treatment strategies for the elderly. Bone blocks were reconstructed from micro-CT images of proximal femoral fracture patients. Apparent Young’s modulus and average stress of cancellous bone along three orthogonal directions were calculated by FEA. There were significant differences in mechanical properties between different regions and between different directions.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.