Time-Dependent Structure of the Upper Atmosphere

Abstract

The physical properties of the upper atmosphere are determined mainly by heat conduction, the heat sources and the barometric law. An analysis of the integro-differential equation which describes these physical processes has been carried out. It is found that heating of the thermosphere due to absorption of the solar extreme ultraviolet (EUV) radiation alone cannot explain the observed diurnal variation of density and temperature, since it would yield a maximum of these properties at about 17h local time, instead of 14h where it is observed. Secondly, if the EUV flux is adjusted to give the observed average temperature, then the diurnal variation in density would be much too large compared with the observed amplitude. Thirdly, it would require an extremely high efficiency for the conversion of EUV radiation into heat, if we compare the required flux with Hinteregger's measurements of the EUV flux. Thus, it is necessary to have another heat source in addition to the heating due to absorption of EUV radiation. If an additional beat source is used, which has a maximum at about 9h local time and a flux of 1 erg cm−1 sec−1, a time-dependent model of the upper atmosphere is obtained that is in good agreement with the observed densities. There is evidence that this additional heat source derives its energy ultimately from the solar corpuscular radiation. In this paper we present the results of calculations for a model in the equatorial and temperature zones of the earth, for those times when the average solar activity corresponds to a solar radiation flux of 200×110−22 Wm−2 (cps)−1 at 10.7-cm wavelength. The physical properties (temperature, density, pressure, scale height, mean molecular weight and the number densities of N2, O2, O, He and H) are given as a function of local time and for the altitudes between 120 km and 2050 km.