Abstract
Tilt error can affect a serious effect to holographic data storage system using angle(polytopic) multiplexing. Because the tolerance about tilt error is very tight it is important to measure the tilt error and compensate it. In this paper, tilt error measurement system with additional red laser and reflection geometry is suggested and servo control experiments are conducted. A servo controller to compensate tilt error is designed using disturbance observer. Amount of tilt is decreased smaller than 0.01 degree and signal-to-noise ratio is increased with the tilt servo controller when 0.216 degree of tilt disturbance is applied.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
