Abstract
Achieving high power conversion efficiencies (PCEs) in ferroelectric photovoltaics (PVs) is a longstanding challenge. Although recently ferroelectric thick films, composite films, and bulk crystals have all been demonstrated to exhibit PCEs >1%, these systems still suffer from severe recombination because of the fundamentally low conductivities of ferroelectrics. Further improvement of PCEs may therefore rely on thickness reduction if the reduced recombination could overcompensate for the loss in light absorption. Here, a PCE of up to 2.49% (under 365-nm ultraviolet illumination) was demonstrated in a 12-nm Pb(Zr0.2Ti0.8)O3 (PZT) ultrathin film. The strategy to realize such a high PCE consists of reducing the film thickness to be comparable with the depletion width, which can simultaneously suppress recombination and lower the series resistance. The basis of our strategy lies in the fact that the PV effect originates from the interfacial Schottky barriers, which is revealed by measuring and modeling the thickness-dependent PV characteristics. In addition, the Schottky barrier parameters (particularly the depletion width) are evaluated by investigating the thickness-dependent ferroelectric, dielectric and conduction properties. Our study therefore provides an effective strategy to obtain high-efficiency ferroelectric PVs and demonstrates the great potential of ferroelectrics for use in ultrathin-film PV devices.
Highlights
The ferroelectric photovoltaic (PV) effect has gained widespread attention in the past decade[1,2,3,4,5] because of its promising applications in solar energy harvesting[6,7,8], selfpowered photodetection[9,10], and information storage[11,12]
The peaks in the range of 42.35° to 42.63° correspond to larger lattice constants: c2 = 4.232–4.259 Å. These results suggest that our PZT films may contain two tetragonal phases: a bulk-like T1 phase that exists near the top of the film and is almost strainfree and a strained T2 phase that exists near the bottom of the film and undergoes lattice relaxation as the film becomes thicker
Our strategy to realize such a high power conversion efficiencies (PCEs) consists of reducing the film thickness to be close to the depletion width, which can simultaneously suppress recombination and lower the series resistance
Summary
The ferroelectric photovoltaic (PV) effect has gained widespread attention in the past decade[1,2,3,4,5] because of its promising applications in solar energy harvesting[6,7,8], selfpowered photodetection[9,10], and information storage[11,12]. The high PCEs (>1%) of ferroelectric PVs were achieved mostly in thick films[6,18], composite films[19,20,21], and bulk crystals[17], all of which have large thicknesses (several hundred nanometers and above). In these systems, severe recombination may occur because ferroelectrics have fundamentally low carrier mobilities and short lifetimes.
Sign-in/Register to view highlights & summary Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
