Abstract
Pre-drying is a potential way to improve the electric generation efficiency of lignite-fired power plant, and steam is a main kind of drying heat source. In conventional pre-dried lignite-fired power system, the steam extraction of regenerative system is led to the dryer directly. The steam extraction must be used by the dryer after throttling, if the energy mismatch exists between the supply of steam extraction and the need of dryer. Two systems of energy supply for the dryer, that the energy of the steam extraction is supplied to the dryer via compressor or ejector, were proposed in this paper to further increase the energy utilization efficiency. These systems were thermodynamic analyzed, and the electric generation efficiencies of these systems were compared. The energy saving boundary was gotten.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
