Abstract
Electrically heated hot points are widely used for drilling in glaciers and ice sheets. To study the effect of input power, axial load, ice temperature, shape, and material of the thermal tip on the hot-point rate of penetration (ROP), a 0.8-m-long drill with 18 changeable thermal tips was designed. The ROP increased with input power for all the thermal tips. Seven tip shapes (cylinder, cosine, ogive, sphere, catenary, parabola, and cone) were tested at the same power level, axial load, and ice temperature, and they exhibited the same ice contact area. The 60° cone-shaped tip demonstrated the highest ROP. The horizontal ring and longitude grooves on the surface of the thermal tips did not improve the drilling performance. The ROP decreased linearly with decreasing ice temperature. Increases in the axial load resulted in increase in the ROP only within the limited range (<20 N or < 8.2 kPa). The ROP of the thermal tip made of copper was more than twice that of the aluminum thermal tip of the same shape. All tested tips were also modeled for temperature distribution inside the thermal tips, and the temperature and heat flux distribution along the outside operating surface of the tips.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
