Abstract
AbstractThis paper reports on the thermal modelling of GaN‐based LEDs. The theoretical calculation was made by combining an analytical simulation employing the Unit Temperature Profile Approach (UTPA) and Finite Element Method (FEM). An interfacing process was made by the optimization of the modelling input parameters used in the analytical simulator. The calculated temperatures of the LED chip inside the epoxy package was compared with the experimentally measured data and the optimized heat transfer coefficients were extracted. The extracted parameters were implemented into the numerical thermal calculation of the package surface using FEM. By the effective interfacing process between the two modelling tools, it is demonstrated that the analytical simulator can be utilized for the accurate prediction of the surface temperatures of LED packaging with non‐flat surface. (© 2004 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
