Abstract
In this paper, UG software is used to model the gears in three dimensions, and the interface technology of UG and ANSYS software is summarized to minimize the model conversion error during the import process. It is used in ANSYS software to calculate and analyze the root stress of the imported gear model. The traditional simplified formula of gear root stress is used to check the calculation results of ANSYS. The verification results show that the results of the two calculation methods are basically the same.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.