The potential for establishment of axial temperature profiles during solid-state fermentation in rotating drum bioreactors.

Abstract

The mixing and heat transfer phenomena within rotating drum bioreactors (RDBs) used for solid-state fermentation processes are poorly studied. The potential for the establishment of axial temperature gradients within the substrate bed was explored using a heat transfer model. For growth of Aspergillus oryzae on wheat bran within a 24 L RDB with air at a superficial velocity of 0.0023 m s(-1) and 15% relative humidity, the model predicts an axial gradient between the air inlet and outlet of 2 degrees C during rapid growth, compared to experimental axial temperature gradients of between 1 and 4 degrees C. Undesirably high temperatures occur throughout the bed under these operating conditions, but the model predicts that good temperature control can be achieved using humid air (90% relative humidity) at superficial velocities of 1 m s(-1) for a 204 L RDB. For a 2200 L RDB, good temperature control is predicted with superficial velocities as low as 0.4 m s(-1) with the airflow being switched from 90% to 15% relative humidity whenever the temperature at the outlet end of the drum exceeds the optimal temperature for growth. This work suggests that significant axial temperature gradients can arise in those RDBs that lack provision for axial mixing. It is therefore advisable to use angled lifters within RDBs to promote axial mixing.