Abstract

The effect of isochronal annealing on the deformation-induced defects in pure Cu and Cu-Ni-Si alloys is studied by positron annihilation spectroscopy. For the cold-rolled Cu, annealing up to 900°C causes a gradual recovery of the deformation-induced defects and monotonous decrease of the hardness. This indicates that its hardening is mainly related with defects such as dislocations. However, for the hot-rolled and quenched Cu-Ni-Si alloy, although there is a partial recovery of defects after annealing below 500°C, formation of additional defects is observed after annealing above 500°C. The hardness of Cu-Ni-Si alloy has a maximum value after annealing at 500°C, which suggests that the hardening of Cu-Ni-Si alloy is not due to defects, but primarily due to the precipitation formed during annealing. Further annealing of the Cu-Ni-Si alloy above 500°C results in over-aging effect and the precipitates lose coherence with the host matrix, which leads to positron trapping by vacancy clusters in the incoherent interface region.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.