Abstract
The aim of this study is to investigate the effect of scan speed and frequency on surface roughness and engraving depth of AISI H13 hot work tool steel. The experimental studies were conducted by fiber laser marker machine. The relationship between the parameters is showed that the highest surface roughness and depth values were achieved at lowest scan speed (125mm/s). The depth and surface roughness of engraved geometry was decreased at increase in scan speed. It was concluded that, the surface roughness and depth can be controlled by scan speed and frequency.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
