The effect of SbCl3 treatment on CdTe produced by close space sublimation method

Abstract

In this study, influence of SbCl3 treatment on CdTe films deposited by the close space sublimation method was investigated. SbCl3 treatment was compared with conventional CdCl2 treated and untreated samples. It was determined that CdTe grew as Cd-rich and there was a slight decrease in Cd-amount after SbCl3 and CdCl2 treatments. In addition, a significant amount of Sb was detected in the SbCl3 treated sample. The samples crystallized in the cubic structure of CdTe. However, graded structures such as phase-I and phase-II with different structural parameters were formed. In the SbCl3 sample, it was revealed that the presence of Sb- caused a slight increase in the lattice parameter, compared to the other samples. Morphological analyses of the samples showed facet and large-small grain structures. CdCl2 treatment caused a slight decrease in grain size, while SbCl3 treatment resulted in a coarser and rougher grain structure. CdCl2 treatment increased transmittance, whereas SbCl3 treatment caused a decrease in transmittance (hence, an increase in absorbance). It was observed that the bandgaps were ∼1.49 eV in all samples, and annealing, as well as CdCl2 and SbCl3 heat treatments did not cause a sharp change in the bandgaps. Photoluminescence spectra revealed the presence of band-edge and shallow-level defect transitions (except CdCl2 treated) in the samples. All results suggest that SbCl3 heat treatment has a significant effect on CdTe and may be an alternative to CdCl2.