The Effect of Hot and Cold Check Tests on Surface Roughness and Glossiness in Varnished Wood Material

Abstract

In this study, specimens from Scots pine (Pinus sylvestris L.), Anatolian chestnut (Castanea sativa Mill.) and Eastern beech (Fagus orientalis Lipsky) tree species, prepared according to ISO 3129, were conditioned according to TS ISO 13061-1. Cellulosic varnish, water-based varnish, and glass polish varnish were applied to their surfaces in accordance with ASTM-D 3023 principles. In the study, roughness (TS 2495 EN ISO 3274 and TS EN ISO 21920-3) and gloss (according to TS EN ISO 2813) values of the samples were calculated after hot and cold check test. Varnished test specimens prepared in 100 mm × 100 mm ×10 mm dimensions were first kept in drying oven at (50±5) °C for 1 hour, then were kept in conditioning room for 1 hour, and then at (-20±2) °C for 1 hour, according to ASTM D1211-97. These processes were accepted as one cycle, and tests were continued until 15 cycles. Afterward, glossiness was measured as perpendicular and parallel to fibers at 60º with a gloss measurement device, and surface roughness values of Ra and Rz were determined with a surface roughness measuring device. According to the results obtained, Scots pine (Pinus sylvestris L.), Eastern beech (Fagus Orientalis Lipsky), and Anatolian chestnut (Castanea sativa Mill.) varnish-coated wood material surfaces all showed a decrease in gloss values after hot-cold shock effect. While an increase occurred in Rz values of roughness for all wooden surfaces, Ra values roughness increased for Scots pine and chestnut and decreased for eastern beech. Gloss and roughness values of surface-treated wood materials against changing weather conditions can determine usefulness of the surface material used. The findings obtained in this study can be useful to manufacturers who use wooden products in the design of marine vehicles and those who export furniture to countries in different climatic conditions.