Abstract

In this paper, a practical issue of the application of cubic boron nitride (CBN) cutting tools for the machining of steel 100Cr6 thin-walled bearing rings is addressed. Three geometries of the commercially available CBN cutting inserts were tested at different machining parameters. The effect of geometry was assessed in terms of surface integrity, considering 2D profile parameters, 3D topography of the surface, and residual stresses in the surface layer. The results were sometimes contradictory, since the same cutting inserts provided the largest and the lowest values of the topography parameters, dependent on different cutting conditions. In general, CBN cutting inserts with XCEL geometry ensured the smallest profile parameters Ra and Rz, and the spatial parameters of Smr1 exhibited the largest values among all tested tools, suggesting reduced wear resistance. Residual stresses analysis did not reveal any inacceptable or potentially dangerous surface layer state after machining.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.